1.
What is the most common attack on a network today?
2.
Which ip address developer can use for research purpose ?
3.
Which NAT allows you to use single public IP for global communication ?
4.
What is the maximum Hop count of RIP ?
5.
Where are EIGRP successor routes stored?
6.
Which of the following is an industry-wide standards suite of protocols and algorithms that allows for secure data transmission over an IP-based network that functions at the layer3 Network layer of the OSI model?
7.
In which mode of VTP a switch can get VLAN information from master Switch ?
8.
In the command “router EIGRP 109” what does 109 signify ?
9.
Which class of IP address provides a maximum of only 254 host addresses per network ID?
10.
Which of the following options are used in standard access lists?
11.
What is the purpose of Spanning Tree Protocol in a switched LAN?
12.
which command you can use to backup IOS of Cisco router ?
13.
If you use either Telnet or FTP, what layer are you using to generate the data?
14.
Which Router Password is stored as encrypted by default ?
15.
You want to implement a mechanism that automates the IP configuration, including IP address, subnet mask, default gateway, and DNS information. Which protocol will you use to accomplish this?
16.
Which protocol works at the Network Layer layer
17.
What is the default Configuration Register mode of CISCO 2600 Router ?
18.
What is the full form of OSPF ?
19.
What is the name of this mode " Router(config-line) #
20.
What would be the proper command to set a DCE clock rate of 56k for a serial interface ?
Your quiz time is about to finish. Few seconds left.
