1.
Which mechanism is used by RIP to find out best destination route ?
2.
In which Configuration Register mode of CISCO 2600 Router ignore startup configuration from NVRAM ?
3.
In which domain switch can divide a network ?
4.
Which statement about MAC addresses is correct?
5.
In the command “router EIGRP 109” what does 109 signify ?
6.
What is the default Configuration Register mode of CISCO 2600 Router ?
7.
What is the full form of OSPF ?
8.
Which of the following is NOT a part of a typical three-layer hierarchical internetworking model?
9.
when link state routing protocol update route information with neighbors ?
10.
Which statement is true about EIGRP ?
11.
You want to ping the loopback address of your local host. What will you type?
12.
What would be the proper command to set an IP for a serial interface?
13.
Which algorithm is used by OSPF to find out best path to destination network ?
14.
Which protocol is used for WAN Communication ?
15.
What is the protocol data unit of Layer 1 of OSI Model ?
16.
Which class of IP address provides a maximum of only 254 host addresses per network ID?
17.
Which key combination you can use to get rommon mode of router ?
18.
What is the name of this mode " Router >" ?
19.
What is the default interval for sending route update message in RIP?
20.
You have an IP of 192.168.0.80 with a subnet mask of 255.255.254.0. How many hosts you can use to make a network ?
Your quiz time is about to finish. Few seconds left.
