1.
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20684570. Another route is from OSPF with a metric of 852. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?
2.
Which command you should use to create VLAN 10 for ABC Department.
3.
Which command displays RIP routing updates ?
4.
Which NAT allows you to use single public IP for global communication ?
5.
You are a network administrator for your company. You have 12 routers from different vendor (cisco, juniper, dlink etc.). Now which protocol will you implement for full network communication(chose the best one) ?
7.
In which mode of switch you can create VLAN ?
9.
To enable OSPFv3, which of the following would you use?
10.
Your company wants to reconfigure a Catalyst 2950. Which actions must be taken to erase the old configuration? (Choose all that applicable)
11.
Which of the following is true of a Switch ?
12.
What is the purpose of flow control?
13.
What type of RJ45 UTP cable do you use to connect a PC's COM port to a router or switch console port?
14.
What command will permit SMTP mail to only host 1.1.1.1?
15.
Frame relay technique uses ?
16.
What is the full form of RIGRP ?
17.
One of the routers in your company has just received information about network 172.16.10.0/24 from multiple sources. Which of the below will the router consider as the most reliable source for network 172.16.10.0/24?
18.
What would be the proper command to set an IP for a serial interface?
19.
What must happen if a DHCP IP conflict occurs?
20.
What is the default encapsulation protocol of Cisco Router for serial interface ?
Your quiz time is about to finish. Few seconds left.
